Removing a Processor

Note:
Two processors are standard in some modules.

Prep steps:

1. Power down and remove power from the server.
2. Remove the access panel.
3. Remove the bezel (or bezel door).
4. Remove the processor air baffle.

Important!
For tower models, lay the system on the right side.

To remove a processor:

1. Locate the processor on the system board.
2. Lift the processor-cage retaining latch.


Important!
The lever must be perpendicular to the board or socket for the processor to unlock.


3. Lift the processor cage upward.
4. Rotate the processor-locking lever to release the processor.
5. Remove the processor/heatsink assembly from the socket.

Caution!
Failure to fully open the processor locking lever will prevent the processor from seating properly during installation and can potentially lead to hardware damage.

To prevent possible server malfunction, be sure to completely close the processor locking lever.

Installing or Replacing a Processor 

To install or replace a processor:

1. Pull the processor-cage retaining latch so that it is perpendicular to the system board.
2. Align the guide holes on the processor/heatsink assembly with the posts on the socket.
3. Rotate the processor-locking lever to hold the processor.
4. Push the processor cage downward.
5. Replace the air baffle.
6. Close the bezel (or bezel door).
7. Replace the access panel.